Milltronics PL-551 Información técnica descargar pdf (Pagina 407)

100

101

SECTION SEVEN - SAMPLE PROGRAMS

N4 Sets a "pierce point" of X0 Y0; moves to its compensated point as established by the

previous block

N5 Calls tool #1's "H" offset, positions Z to .1, and turns on coolant

N6 Feeds Z-.375 at 5 ipm

N7 Line move to X0 Y2 at 25 ipm

N8 CW arc 2" radius using an XC2 YC2, an estimated end angle of 45° degrees, and an end

option (round corner) of .0001" radius

Note: The end option of a .0001 radius forces an intersection between the arcs.

N9 CW arc 2" radius using an XC4.8284 YC2 and an end angle of 0 degrees

N10 Line move to X6.8284 Y0

N11 Line move to X0 Y0

N12 Establishes a point after retract of X0 Y99

Note: Machine does not move to this position.

N13 Turns off cutter compensation

N14 Rapids Z to .1, turns coolant off

N15 Turns spindle off

Conversational Program Sample 5

Event 0 of 9

Program Setup

Program name [SAMPLE 5 ]

Dimensions [Absolute]

Units [English]

Work Coordinate [---]

Setup Notes:

[ ]

---------------------------------------------------

393

1 2 ... 402 403 404 405 406 407 408 409 410 411 412 ... 440 441

Comentarios a estos manuales

Sin comentarios

Milltronics PL-551 Información técnica Pagina 407

Comentarios a estos manuales

Relacionado con productos y manuales para No Milltronics PL-551