Milltronics PL-551 Información técnica descargar pdf (Pagina 304)

100

101

SECTION FOUR - PREPARATORY FUNCTIONS (G CODES)

Notes on Canned Cycle Specifications

Note 1: The spindle must be turned on by M code, M3 or M4, before the canned cycle is

specified.

Note 3: If a block contains a Z position by itself, drilling will not be performed.

However, the Z axis will rapid to this point. This can be used to manipulate a

tool up and over obstructions without disabling the canned cycle.

G00 X____

G4 P (Drilling is not performed. Drilling data P is not changed by G04 P__.)

M3 Spindle CW

G __ __ ......Correct

M5 Spindle Stop

G __ __ ......Incorrect (M3 or M4 must be specified before this block.)

Note 2: If the block contains an X and/or Y move, drilling is performed in canned cycle

mode. If the block does not contain an X and/or Y move, drilling is not

performed. However, when "G4 X___" is specified, drilling is not performed

even if X is specified.

G81X____ Y____ Z____ R____ F____

F (Drilling is not performed. X Y feedrate is updated.)

M (Drilling is not performed. Only the miscellaneous function is executed.)

290

1 2 ... 299 300 301 302 303 304 305 306 307 308 309 ... 440 441

Comentarios a estos manuales

Sin comentarios

Milltronics PL-551 Información técnica Pagina 304

Comentarios a estos manuales

Relacionado con productos y manuales para No Milltronics PL-551