Milltronics PL-551 Información técnica descargar pdf (Pagina 326)

100

101

SECTION FIVE - MISCELLANEOUS FUNCTIONS (M CODES)

Rounded Walls (M96)

M96 can be used for rounding walls in pockets or on islands. This command takes a start angle,

wall radius, first and final Z depths, and the Z increment as parameters. The M96 must be within

a while-wend loop. The tool radius, parameter #160 (the current Z depth) and cutter

compensation must be on to use the round walls feature. The M96 sets parameter #162 to 2 when

the cycle is completed. The M96 assumes that a ball-nosed tool is used. Rounded walls also use

an offset round/tapered walls parameter to determine where the first cut is.

Example 1: Offset Island Rounded Walls

Offset round/tapered walls parameter = yes

First cut is offset to avoid overcutting vertical wall.

Example 2: No Offset Island Rounded Walls

Offset round/tapered walls parameter = no

Offset is not needed to cut this part.

312

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 440 441

Comentarios a estos manuales

Sin comentarios

Milltronics PL-551 Información técnica Pagina 326

Comentarios a estos manuales

Relacionado con productos y manuales para No Milltronics PL-551