Milltronics PL-551 Información técnica descargar pdf (Pagina 352)

100

101

SECTION SIX - PARAMETRIC PROGRAMMING

INPUT The INPUT statement is used for data input from the front panel.

Example: INPUT (X START POSITION) P1

The operator will be prompted to input data.

The operator can use the data displayed by pressing the ENTER key. If ESC is pressed

during an input statement, the program will be terminated.

The HDW command can be used to enter the handwheel mode during a program. A

comment may be added to prompt the operator during the HDW command. HDW is

ignored when verifying a program.

Example: HDW (TOUCH THE TOOL TO THE PART) prompts the operator with

the following message.

The operator presses the <enter> key after handwheeling the machine. If <esc> is pressed

during handwheeling, the program will be terminated.

To manually set and clear input/output pins, refer to the following.

CLR Clear an output pin.

Example: CLR X7 (clears X output #7)

SET Set an output pin.

Example: SET Z3 (sets Z output #3)

338

1 2 ... 347 348 349 350 351 352 353 354 355 356 357 ... 440 441

Comentarios a estos manuales

Sin comentarios

Milltronics PL-551 Información técnica Pagina 352

Comentarios a estos manuales

Relacionado con productos y manuales para No Milltronics PL-551