Milltronics PL-551 Información técnica descargar pdf (Pagina 329)

100

101

SECTION FIVE - MISCELLANEOUS FUNCTIONS (M CODES)

Notes on Rounded Walls

Note 1: The first cut at the first Z depth is always offset the entire tool radius.

Note 2: The first Z depth should be at the top of the surface to cut.

Note 3: If the wall radius and start angle will not span the first Z depth and final Z depth,

an error will occur.

Start angles are defined and illustrated in the following drawings. Negative start angles are

allowed.

If you use an E0 or no E on the M95 (or M96) block, the control uses a ball nose on the wall.

Any other E# on the M95 (or M96) instructs the control you are using an end mill. The offset

round/tapered walls has no effect on the end mill option.

315

1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 440 441

Comentarios a estos manuales

Sin comentarios

Milltronics PL-551 Información técnica Pagina 329

Comentarios a estos manuales

Relacionado con productos y manuales para No Milltronics PL-551