Milltronics PL-551 Información técnica descargar pdf (Pagina 156)

100

101

SECTION THREE - CONVERSATIONAL INPUT SCREENS

Event 4 of 4

End of Program

Spindle off [Yes]

Coolant off [Yes]

Z to Toolchange [Yes]

X Position (home relative)[ ]

Y Position (home relative)[ ]

---------------------------------------------------

The following graphic illustrates the sample mill program using the round walls option on the

start mill cycle.

0° is a vertical wall; 90° is impossible. The round wall also has an option to use an end mill tool.

Cutter comp must be on to use the tapered walls option. The first Z depth should be the top of the

wall. The first pass is offset by the entire tool radius.

Note: See page 312, Section 5 for further information on rounded walls.

F5 (Pockt) Mill-Pockt

The F5 (Pockt) pocket mill selection brings up the following soft keys.

F1 (Setup) Mill-Pockt-Setup

The F1 (Setup) screen is used to set parameters necessary for the circular, rectangular and

polygon pocket routines. Setting parameters must be done prior to any pocket routines. The

manual pocket clear routine does not need the setup screen.

142

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 440 441

Comentarios a estos manuales

Sin comentarios

Milltronics PL-551 Información técnica Pagina 156

Comentarios a estos manuales

Relacionado con productos y manuales para No Milltronics PL-551